Mavericks — Technical Data Sheet

Key specifications

Coverage values are indicative. Always create a representative sample panel under project lighting to confirm yield, colour and wave language before large‑scale work.

Compatible substrates

Mavericks is suitable for most interior vertical substrates once they are correctly prepared. Typical substrates include:

• New gypsum plaster and skimmed plasterboard (fully cured and dry).
• Existing sound acrylic paints, after cleaning, light abrasion and de‑dusting.
• Cement–lime renders and mineral base coats that are stable and free from efflorescence.

Substrates must be sound, clean, dry and cohesive. Remove all loose, flaking or chalking coatings, repair cracks and defects, sand smooth and de‑dust thoroughly. Apply the Nautilus undercoat to regulate absorption and create a uniform base before applying the Mavericks wave effect.

System build — Mavericks

The exact specification will vary with substrate, colour and project demands, but the core logic is:

• 1. Substrate preparation
  Stabilise, repair, level and sand to achieve a smooth, uniform surface. Remove dust and contaminants.
• 2. Nautilus undercoat
  Apply Nautilus (1–2 coats) by roller/brush as per the Technical Data Sheet. Allow to dry thoroughly between coats and before the effect coat.
• 3. Colour set‑up
  Add the two L50 colour packs (two different tones) to the respective Mavericks containers and mix until homogeneous, ensuring crystals and pigments are fully dispersed.
• 4. Mavericks wave effect coat
  Working in 1–2 m² areas, load each side of PV 102 Double Brush with a different colour and apply overlapping strokes. While the product is still open, pass lightly with PV 103 to sculpt the sea‑wave pattern and spread crystals, finishing with gentle cross‑strokes to remove sharp marks.

For complex geometries or demanding projects (double‑height spaces, curved walls, stair cores), mock‑ups or sample walls are recommended to refine wave language and transitions before full installation.

Performance & maintenance

Performance notes

• Provides a durable decorative finish for vertical interior surfaces when applied over stable, suitably primed substrates.
• Intended for feature walls and focal areas, not for whole‑building coverage.
• Not designed as a waterproof coating on its own; for permanently wet areas, see Waterproof Artistic Walls.

Cleaning & care

• Allow approximately 15 days for full curing before first cleaning.
• Dust regularly with a soft cloth, microfibre or feather duster.
• For marks, use a soft, slightly damp cloth and mild neutral detergent where necessary. Avoid aggressive scrubbing that could burnish the surface or alter the crystal highlights.
• Do not use abrasive pads, scouring powders, bleach or solvent‑based cleaners.

Health, safety & environment

• Water‑based formulation with low VOC content for interior use.
• Apply in well‑ventilated conditions; avoid inhalation of spray or fine mist.
• Avoid contact with eyes and skin; wear suitable gloves, eye/face protection and work clothing.
• Keep out of reach of children. Do not eat, drink or smoke during use.
• Store in tightly closed original containers between approx. +5 °C and +30 °C; protect from frost and direct sunlight.
• Dispose of residues and empty containers in accordance with local regulations. Do not discharge into drains or waterways.

Waterproof Artistic Walls & technical resources

Mavericks is intended for dry interior walls. In selected designs it can also appear as the visible finish in areas built with the Waterproof Artistic Walls framework, where a full E‑VOLUTION PLUS body provides waterproofing and Mavericks is applied as an artistic top layer. These multi‑system builds are always specified and controlled by Italian Surface Finishes on a project‑by‑project basis.