01 / Quiet depth
Meteore 10 Intonaco
Light traces the hand-worked relief. Begin with the application, then find the colour that belongs in your room.
Explore the material ↗Soft mineral shimmer
Sabulador Soft
Fine grain and delicate reflections, from pale mineral colours to deeper tones. Choose the base as well as the colour, with a brushed or streaked application.
Explore colours, application and the original catalogue. Loading the colours…
03 · From material to wall
Made through the method.
Preparation, application and the selected materials belong to one finish. Review the complete cycle before beginning the work.
- 01
Prepare the ground
Create a sound, even surface and follow the PRIMART 600 preparation described in the original catalogue. ISF confirms the preparation for your project.
- 02
Work the first coat
Distribute the fine grains with the documented brush movement.
- 03
Complete the character
Apply the second coat with the chosen brushed or streaked method.
04 · Before you begin
The practical detail.
Lux Argento 100 and Oro 200, Matt Gesso 500, and the untinted Alluminio 300 and Bianco Pieno 400 bases each have a distinct identity.
Read the complete manufacturer catalogue →Follow the application
Apply with PV09, working in all directions. Wait about 4 hours at 20°C. Apply the second coat with the same technique.
Follow the application
Roll with PV95 in all directions, finishing from top to bottom. While wet, use PV88 or PV89 up and down, leaving streaks as straight as possible. After about 4 hours at 20°C, repeat the roller and finishing sequence for the second coat.
New, sound & older surfaces
New surfaces: fill, allow to dry and sand. Apply PRIMART 600 diluted 15–20% with water. Wait about 4 hours at 20°C before Soft. Sound existing surfaces: where clean and not peeling, use one coat of PRIMART 600 diluted 15–20%. Older peeling surfaces: remove non-adhering paint and wash. The catalogue specifies PRIMART 600 diluted 50% as a fixative, then after about 4 hours a second coat diluted 20–30%. Review the support before proceeding.
Coverage, drying & care
The catalogue coverage belongs to the documented effect; do not multiply it into an order here. The specialist planning application checks the system and scope.
Tinting, trial & batches
The documented tinted families use Lux Argento 100, Lux Oro 200 or Matt Gesso 500 with COLORI’, or the VALCLONE system. The same number and letter can occur under different bases; keep the base attached. Test the complete cycle on a small wall. Natural products and resins react to humidity, heat, ventilation and application method. Each application is individual. The manufacturer warns that shades may vary 20–30% from catalogue reproductions and between batches. Mix all material in a large container before application to avoid batch differences.
Keep the manufacturer source close
Store tightly closed between +10°C and +30°C. Read the full manufacturer application and safety information before use. Consult the tutorial for the intended effect. The notes here come from the supplied Sabulador Soft catalogue, including its application and technical pages. They do not certify a particular substrate or installation.
Samples and colour in your room
The same finish changes with light, application and the surrounding colours. Use a physical sample and a trial area to confirm the intended result.
See sample options →Visit the London Studio →
