Klondike Ferro

Apply Primer 1200 to a sound, clean and repaired surface; allow 4 hours at 20°C. Brush on one covering coat of Ferro with crossed strokes, reworking while wet with an unloaded brush. Allow 8 hours. Dab Oxidising Solution with PV32 in patches, then fill the remaining spaces. Add a second coat after 3 hours. Further coats depend on the intended oxidation. After the development period described in the catalogue, apply two coats of Finish V16, 2 hours apart. Trial the complete cycle on a small area and follow the full manufacturer instructions.

Apply Primer 1200 and allow 4 hours at 20°C. Brush Ferro in short strokes in every direction, reworking with an unloaded brush. After 10 minutes, dab L50 Col. 309 Copper with the compact side of PV32. After 8 hours, dab Oxidising Solution in patches and then into the remaining spaces. Add a second coat after 3 hours. After the development period described in the catalogue, apply two coats of Finish V16, 2 hours apart. Trial the complete cycle and follow the manufacturer’s timing for the developed appearance.

Apply Primer 1200 and allow 4 hours at 20°C. Brush one covering coat of L50 Col. 301 Aluminium vertically; allow about 4 hours. Brush Ferro into jagged vertical strips of different lengths and allow 8 hours. Apply Oxidising Solution vertically over the whole surface, adding a second coat after 3 hours; a third coat is optional. After the development period described in the catalogue, apply two vertical coats of Finish V16, 2 hours apart. Trial the complete cycle before beginning the wall.

The lower Ferro consumption in the Galvanised route describes its markings over the aluminium ground. It does not describe the consumption of the complete wall system.

Remove unstable or chalking coatings and impurities, wash appropriately and repair where necessary. Apply a covering coat of Primer 1200. It is the only component diluted here: 15–20% with water. Continue after 4 hours at 20°C. Apply above +10°C and below +30°C. The finish is satin. Clean tools with water and soap; store tightly closed above +5°C and below +30°C. Ferro is an interior decorative system. A bathroom illustration is not evidence of waterproofing or suitability for floors, shower areas or permanently wet surfaces. Discuss the actual exposure with ISF.

The manufacturer warns that shade and effect can vary considerably from the catalogue and between batches. Test a complete cycle on a small area. At a batch change, finish at a corner, then mix remaining and new material together before continuing. The English application and technical text in the supplied manufacturer catalogue is the source for these notes. Follow the product and safety information supplied with the material.

The same finish changes with light, application and the surrounding colours. Use a physical sample and a trial area to confirm the intended result.